1.2.6 pro on v2 overlay

[jimbo]

hi all,i have updated to traktor pro and updated it to 1.2.6 version but i wanna download mappings from dj tech tools for my v2 overlay i have.Is this still possible????????????.I have my vci 100 se since x-mass and still only this far

[BentoSan]

Older V2 mapping are available here - http://www.djtechtools.com/forum/sho...713#post104713

[pilmat]

Yep, V2 mappings will work fine with 1.2.6.

Phil.

[Citizen_Insane]

All previous mappings should work with 1.2.6
Also click the mapping tab just below the banner, link saying "Older V2 mappings are Available Here" will take you to the forum post with the 2.4 and 2.5 mappings available for download.
Hope this helps.

P.S. Bento beat me to the punch.

[jimbo]

try,d to download them files but noting there on 2.4 and 2.5.it says download or find file.when i downloaded the file it cant find it

[BentoSan]

try,d to download them files but noting there on 2.4 and 2.5.it says download or find file.when i downloaded the file it cant find it

Right click the download link and press rather "save target as" or "save link as" then save it wherever you like so you cant lose it

[jimbo]

sorry what it says when i i press on the 2.4 and 2.5 it says FIND or SAVE file.So when i saved it cant open it because windows needs the programe that created it

[Citizen_Insane]

Just load up traktor, go to "Preferences > Controller-Manager"
Under "Device" click "Add..." and then click "Import". Then select either the 2.4 or 2.5 mapping .tsi file from the directory in which it is located.

[jimbo]

ok did what ye siad,so its easy as that.J ust have to ask you a dumb question.Whats the diff between 2.4 N 2.5.

[Citizen_Insane]

Not too sure. Probably a few minor differences.
In the folders that you downloaded with the .tsi files there should be a .png of the overlay which shows the mapping, comparing the two images should give you a good idea of any differences.