-
Tech Wizard
T Pro - Saving changes after moving cues and loops.
After using move mode, (such as shifting the start of an existing cue or loop in advanced tab) I couldn't figure out how to save changes - It turns out you have to simply remap the cue. - here is the answer from Dj Kad on the NI forum:
Well...since u are storing loops i think you have one or more button for recall them right? well...
Store a loop after mods:
Button For store Loop 1:
--------------------------
Select Hotcue > Hold > Hotcue1
Map Hotcue > Hold
Store Cue/Loop >Trigger
Button For store Loop 2:
--------------------------
Select Hotcue > Hold > Hotcue2
Map Hotcue > Hold
Store Cue/Loop >Trigger
Button for jump to Loop 1:
--------------------------
Select Hotcue > Hold > Hotcue1
Jump to Act loop > Trigger
Button for jump to Loop 2:
--------------------------
Select Hotcue > Hold > Hotcue2
Jump to Act loop > Trigger
You have 2 Possibilities for activate loops:
Using a separated button (with only the function "Loop Active Toggle")
Using Buttons 1,2,3,and so on (assign to each button the function "Loop Active Hold" ...you will have to mantain pressed the button cause if u assign "Toggle" 2nd time you press a button it will disable/enable loop in a weird way)
P.S.
For use same buttons for store/jump (1,2,3,4,5) you can use a button (Shift) that just change modifier value
Last edited by Kama; 11-14-2008 at 06:14 AM.
-
Tech Guru
Great post, good information. Thank you!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks