-
-
Load The Drivers into DJTT Site!
Why does any buddy from the DJTT makers a Support Blog into this site for every buddy ho need Drivers for VCI or Midi Fighter ????
Is this not Easyer for all ??
-
Tech Guru
There are no drivers; the device should be class compliant. Plug it in and off you go. I think what you're saying is when you turn on Traktor only one of 2 midifighters actually works -- do you have different mappings on each one? I have this problem and it's annoying but to fix it, every time you restart traktor, you have to go to "Controller Mappings" in the preferences and re-select the MIDI Fighter ports in and out on the one that doesn't work. Trial and error to get it right the first time then do it every time you restart Traktor. Annoying yes - it adds about 5 minutes to every setup - but it does the trick for now.
-
-
crying face
ok guys nothing was work did you got any other ideas?
-
Tech Guru
I think it's not clear what is actually the problem; can you explain more carefully what it is you're trying to do and what is actually going wrong?
-
DJTT Super Moderator
Hi Wishmaster,
If you took the time to look you would find that the "Support Blog" does actually exist in the form of the midifighter section of the forum.... in which you posted this thread.
This problem can generally be fixed by reflashing the midifighter in question with the latest firmware
Here are two stickies which describe the process
http://www.djtechtools.com/forum/showthread.php?t=11511
http://www.djtechtools.com/forum/showthread.php?t=17824
The first describes how to find and use the software neccesary for the update, the second describes a fail safe method of putting the midifighter into firmware update mode.
Feel free to PM with any issues you have.
-
Hi @ all, got it work with help from the Pictures to get the MF into Bootloader mode.
So now i dont know how to Flash it like "Fatlimey" in his instruction!
I got some Problems to understood the Steps by using the Pogram "Flip" (i use a PC, not mac)
Maybe Somebody can give me a easier instruction :-) to get this work.
-
DJTT Super Moderator
What stage are you up to?
It is far easier on a PC
Have you installed FLIP?
Are you getting any error messages?
-
Good News!!!!
I know that i do not have good English language skills, but after i read the Instructions again again and again i 1. understood it by my self and took the MF to run.
Sometimes humen need a little patience right, ( just like me ) ;-)
Thanks for all you guys
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks