Hello,
Just got my VCI-100 and started playing around with it a little bit. Right now just with Traktor LE but I also tested this with the Traktor PRO demo. After playing around with it a little bit I noticed something that I think should not happen with firmware 1.2.
If I spin the jogwheel in vinyl mode and let go of it traktor continues to "scratch" back or forward. I was under the impression that with the new firmware scratching stops as soon as you let go of the jogwheel. For testing purposes I had a look with MIDI-Monitor.
Touching the jogwheel of Deck A I get:
B6 On
B6 Off
C2 On
A#1 On
<releasing jogwheel>
A#1 Off
C2 Off
Looking at the mapping in Traktor PRO I saw that "Scratch" for Deck A was set to A#1 <hold>. So for me scratch mode should be enabled when I touch the jogwheel and immediately stop if I let go of it.
Am I misunderstanding something here?
Kind regards and thank you for this very informative site,
Mike
My 1.2 check:
* Green Sticker near the serial Number
* Pressing both "vinyl mode" buttons at the same time turn off the jogwheels.
* Switching back to the "old" mode did not give me A#1 events
Bookmarks