Traktor mapping tips, tricks and questions.

[fuzzywussti]

Tweaking controller range for monitor level LED output should do the trick.

From down to up:

-Button 1 / 0.000 - 0.050
-Button 2 / 0.000 - 0.120
-Button 3 / 0.000 - 0.350
-Button 4 / 0.000 - 0.480
-Button 5 / 0.000 - 0.680
-Button 6 / 0.000 - 0.760
-Button 7 / 0.000 - 0.875
-Button 8 / 0.000 - 0.970

Done! Thx very much man, really useful advice!

[Stewe]

Done! Thx very much man, really useful advice!

You are welcome! I'm glad you sort it out.

[3dask]

how map samples on deck c ??1.jpg

[Stewe]

how map samples on deck c ??1.jpg

Add in > Remix deck > Slot Capture/Trigger/Mute

[muffintop]

Done! Thx very much man, really useful advice!

I always made my top LED red, next one down amber, then yellow. The next 5 down are just green. Helps me keep an eye on my output without always having to look at the screen.

[Eljosh]

Hey guys, this is probably a bit of a noob thing but I can't seem to find it. But I have a launchpad and an X1. I have instant grad mapped on the launch pad for decks A and B, and I want map the effects back on to the X1. Because I tested the instant grad mapping, by changing the effect and then hitting the effect on the launchpad and it does change back. So I'm asking, how do you map in an effect to change when you hit the button? Like I want to add filters to the bottom to knob on the X1 for deck A and B. I've tried to figure it out. Thanks guys.

[Stewe]

Add in > FX Unit > Effect Selector / type-button / mode-direct / value-Filter

[Eljosh]

Ok, cool thanks, I knew it had to be something simple like that.

[Stewe]

I'm glad that helps

[celas]

Hi Guys !
Hope you're well!
I've a question. I use APC40 for all traktor control stuff.
After updating the Traktor to 2.6 version, the leds on my mapping doesn't stay "on" when i put on it. The light is off.

Someone have the same problem?

Thanks for your help !