Traktor mapping tips, tricks and questions.

[Dax]

this help alot - thank you

one final - can you type out to recipe for the modifier button ? i mean the magic one button which will indicate modifier is on.

[Stewe]

Use 'Add Out' and select same modifier number which you are using for toggling between modes. Hope this helps, and if I didn't made myself clear enough let me know.

[Dax]

i am still so lost on creating the first button.
i think i understand that once I create the 1st button to switch decks, then i'll make all my new controls for C/D and have M2 selected to some value?

[Stewe]

OK. Didn't knew you're still struggling with main button, I'll give example for modifier 1 but you can use any available in your mapping:

Modifier 1 / condition M1=0 / button / direct / value=1
Modifier 1 / condition M1=1 / button / direct / value=0

[midinoob]

@dax
So using the modifier u make your controls, like play
For deck a the modifier would be set to m1 = 0
Deck c mod would be m1 = 0

[Stewe]

@dax
So using the modifier u make your controls, like play
For deck a the modifier would be set to m1 = 0
Deck c mod would be m1 = 0

He want to layer it as a/b and c/d so that should be a bit different.

[Dax]

ok
my controller has some shift function currently but I cannot seem to get that "shift" on anything other than a "hold"

in light of the above I have taken your advise but using Mod 2
so i went and pushed the "add in" button and created two lines
1: i chose mod 2 in the drop down and then: condition M2=0 / button / direct / value=1
2. i chose mod 2 in the drop down and then: condition M2=1 / button / direct / value=0

i figured after this button was set up when I pressed it i would suddenly have no controls as if the slate for c/d was blank. . but to no avail, when I pressed button #46 on my controller no change, i was still controlling A/B

[Stewe]

Can you share your current mapping here? Maybe I should look in to see what seems to be issue.

[Dax]

as in upload my tsi ?

[Dax]

i truly believe i am just mis-understanding something and not creating properly. . .