Traktor mapping tips, tricks and questions.

[Stewe]

I didn't test it so can't tell for sure. As I said before, try typing in different values in min/max MIDI range slots and see it for yourself.

Something tells me they aren't.

[Deniz343]

That's what I thought when I started to research this device, but then after a couple of YouTube videos and forums at least I thought it might have red and orange colors.

[Stewe]

Add in > Deck Common > Move > Mode Selector / type-button / interaction-direct / value - loop out
Add in > Deck Common > Move > Size Selector / type-button / interaction-direct / value - loop
Add in > Deck Common > Move > Move / type-encoder / interaction-relative

Command for 2fx/4fx toggle doesn't exist, you can set it only from preferences.

[DarioDeLima]

thanx , you where spot on, figured it out appreciated

[st3pupdj]

hi guys, looking for some help if possible, I'm using a launchpad and trying to map Gater effect to 3 buttons with 3 different knob rates.
So I got the basics mapped to the 3 buttons: fx button HOLD, Knobs set as buttons DIRECT to the corresponding values I want.
My problem is that although the 3 buttons all work, I can't roll up and down through the buttons because if I let go of the first button while holding the second button, the effect is still switched off.
I assume this is because the 1st button is still sending a midi-off signal.
Any help would be appreciated.

[Stewe]

I think this can be done with creative usage of modifiers.

[st3pupdj]

I think this can be done with creative usage of modifiers.

I have tried modifiers but they seem to have the same problem in that when i release the button the modifier also resets back to "0"

[Stewe]

Is there any specific reason why you don't want to keep other buttons holding while performing this combination?

[st3pupdj]

It's more to do with rolling up then back down through the knob range. If i hold button 1 at 10%, then i can press button 2 at 50% and it works fine. The issue is if I want to go back to button 1 i have to let go of one of the buttons at which point the effect stops working. This is no good for fx like beatmasher because the sample point changes if i turn off the button even for a split second.

[Stewe]

I've made two buttons that act as you have described but adding third button in this loop requires a shit load of modifiers and maybe it's impossible to achieve... Will give a few more attempts to make this work but it doesn't promise much of success really.