Traktor mapping tips, tricks and questions.

[Stewe]

No worries, should work just fine

[euphoria676]

Did you assign modifier conditions for commands that are mapped for jogwheel?

hi so i tried out a lot by now.. i tried to map it to all 4 cogwheel-mode buttons (after erasing the original mapping for that specific button) an i tried it with the pitch bend +/- buttons... actually none of them do the job i want... when i map it to any button i press it and the fx dry/wet decreases 10%. thats it... no contorl with jogwheel possible...

[klarkypr]

Hi, i think this is my first post so hello to everyone. I have a APC20 and i'm trying to make the mapping for the Hot Cues. I've been able to make the cue mapping but i haven't been able to make the leds work. I'm in Traktor 2.5.

This are my steps:

- add in > select / set store hot cue > hotcue 1 > deck a
This step works

- add out > ??????????????? I don't know if I need to use "select / set store hot cue" or what. And what parameters i need to use.

Please I need some help here . I'll be very grateful if you guys help me.

Thank you in advance. I'm new in all of this

[Stewe]

Add out > Track Deck > Cue > Hotcue x Type

[klarkypr]

Add out > Track Deck > Cue > Hotcue x Type

Thanks. I've tried that but i don't know what parameter use to make the led stays on. Because when I press the led (apc20 button) the led turn off

I dont know what are the control range or midi range to use

Thanks

[Stewe]

I'm not an APC user so can't really assist on that. But I've seen that been posted before in this thread and mappings forum. You might need to search a bit or wait for other members to reply.

If I was you I'd play with different values and see if I could find solution myself.

[TreTuna]

Hey Stewe, maybe you can help me out here... Or anyone else out there....

I'm trying to map a single button to flip through the FX routing (Send, Insert, Post-Fader). So I tried mapping it to a button with Inc value, but of course once it gets to the max value, it doesn't come around to the lowest again. So it stops and I'm left in Post-Fader mode. I am trying to get this rotating function to work on a single button without any modifiers as this is for the big Maschine mapping I'm working on and I'm going to most likely need all the modifiers I can get!

[Stewe]

Hey Tre, I've just check this and you are correct, the value indeed stops at post fader mode using 'INC' interaction mode. I'm sure this can be mapped using a modifier with three values but you'll need to set this in loop so once a last value has reached the next hit of the button causes a modifier value to jump at first one (let me know if you need to know how to map this).

If you have burned all modifiers in your current mapping you can simply add a new generic device which brings you another set of eight modifiers.

[TreTuna]

That's what I figured I was going to have to do... Just wanted to avoid if possible and not use the modifier.

This Maschine Mapping is already going to be using about 7+ devices most likely, just trying to keep that to a minimum since it already takes me 30 seconds to open the preferences due to how many devices I have in there!

[Stewe]

I know what you're saying mate! My last mapping for behringer had 13 devices and took more than a minute for preferences to pop up. I think that NI should add more modifiers in the house any time soon and keep up with current needs of their users. Something like at least double it could keep # of devices low and prevent traktor to take a neap every time any device is loaded.

Also that can help when it comes to using multiple controllers with ultimate mappings at the same time. Seems they have no interest in doing this tho... Hopefully Pro 3