Traktor mapping tips, tricks and questions.

**jmastio** · 03-19-2013, 03:19 PM

Hi guys
I'm currently mapping the armyfoes' mapping for sweep drama / build up on my Traktor S4.
So far, I have mapped the left shift button to trigger this mapping on deck A and the right shift button for the deck B.
However the purpose of this mapping is to make some nice transitions so it has to work on the deck set as the master deck (the first one that was launched).
So I was wondering whether it exists a second modifier condition in order to trigger this on the current master deck ?
This will simplify my mapping and also no more brainstorming while mixing to figure out which shift button I should press ;-)
Thank guys
See u
Jérôme

**groovemixer** · 03-19-2013, 04:10 PM

Originally Posted by Stewe

That's strange... I don't have 3D to give you exact MIDI ch and velocity input for this but there is much better chance to find your answers if you are looking for help in MF forum.

http://forum.djtechtools.com/forumdisplay.php?f=26

Great thx!!

**Hylfe** · 03-23-2013, 09:24 PM

I use a K2 and have been using a lot of different mappings but I want to utilize every knob in traktor and there isn't a mapping out there like that. I have a page on the controller with dedicated high, mid, low control on 3 knobs but on a seperate page I would like to have the super eq knob with my dedicated gain and filter knobs. So is it possible to have a knob control all 3 bands of eq?

**Stewe** · 03-23-2013, 09:28 PM

Yes, just map all three commands for the same knob.

**Hylfe** · 03-24-2013, 08:17 PM

Can I change the starting position of the individual eq knobs so that they do a roll? Such as having the bass be lower start at halfway between being completly cut and being at exact 0% at the midpoint.

**Stewe** · 03-24-2013, 08:42 PM

You might need a midifighter pro style superfader (two CC massages) to get that behavior.

**Hylfe** · 03-24-2013, 10:35 PM

Damn but its alright just means I need to get more knobs lol. Do you know why on decks A,C,and D the move command moves the loop that I have active but on deck B when a loop is active the loop doesn't move when I move through the waveform. Do you know how I could get B to work like A, C , and D I have erased and duplicated the input from one of the working ones but that doesn't do the trick.

**Hylfe** · 03-26-2013, 04:17 PM

Is there a way to put all 3 eqs on one knob while having a button dedicated that toggles which eq is active? I want to have control over 3-band eq on the same page that I have my gain and filter knobs on my k2. Is this possible?

**Stewe** · 03-26-2013, 04:20 PM

Map modifier to three buttons.

Button 1: M1=1
Button 2: M1=2
Button 3: M1=3

Then map all three EQz to one knob and assign modifier conditions for each state and frequencies.