I'm trying to connect my Faderfox DX2 (midi channel 16) to my PC via the MIDI IN and USB MIDI OUT port on the M-Audio UC-33e. I'm able to receive signals from the UC-33e (in Traktor and MIDI-OX), but not from the DX2.
From the UC-33e instruction manual:
I also enabled the MIDI OUT FROM USB mode on the UC-33e, but still got nothing.The MIDI in plug can be used to interface another MIDI device to your PC, via the USB port. Data received from this device will be transmitted via the
UC-33 to the PC.This is achieved using a second USB MIDI out. So, when you select the MIDI devices section of your sequencer you will see two UC-33
USB MIDI Ins.The first of these is used to receive the UC-33 controller data, the second is used to receive data from the other device connected to the
UC-33’s MIDI IN plug. So, the UC-33 is acting as a MIDI-to- USB interface for the other MIDI device.
To test where the problem was, I connected my Livid Ohm (which does work when connected directly to the PC via USB) from its MIDI OUT to the UC-33e's MIDI IN port. The PC, still, didn't register any MIDI input from the Ohm. I think the problem might lie in the UC-33e.
Can the UC-33e be used as a MIDI interface for other devices?
What can I do to get the Faderfox to work?
Thanks
Bookmarks