Hey Guys,
I have been trying to flash my VCI-100 for about a week now, trying a couple of different computers using a Serial -to- Serial cable and a bunch of settings.
I have been getting the 15024 error no matter what I have tried.
Initiating BOOT SCI sequence
Attempting 9600
Attempting 4800
Attempting 2400
Attempting 1200
Error No 15024: Boot failed
Initially I tried powering the unit off of the PC usb, recognizing that when i power it up, only a single red light tuns on, and with the upgrade kit attached when it powers up no red light, so I assmued it was in boot mode. HOWEVER, I read one user say that they powered the unit with their macbook and that solved the problem. I tried powering the unit with my macbook, and realized that even with the upgrade kit attached, all the buttons and jog wheels light up so apparently I am not in boot mode.
Upon further inspection of the upgrade kit, I noticed something interesting on the solder points of the header that attaches to the VCI-100. solder from two of the pins (the two closest to the serial number stamped to the upgrade kit) has bridged across so that both pins are connected. Im just wondering if this could be giving me the problem and if I can just suck this solder away so they are no longer touching each other?
Sorry for the long question but I wanted to be as descriptive as possible.
Thanks for any advice.
Bookmarks