The VCI-100SE 3.6.4 Mapping for Traktor Pro 2

[gavgrant]

ALright u have to find the play pause trigger in the mappings. But ur looking for the play pause out. There might be one already for the other side but if not then u have to add one to the out of the specific button u are pushing. Also just try reloading the mapping a couple times

I have tried to load the mapping a couple of times but no joy.

I can see Play Pause out's - there are there for decks a, b c & d.

any ideas??

[JDT-NYC]

Is there a way to highlight decks C and D with the new VCI-100SE 3.6.4 traktor pro 2 .tsi mapping? I was able to see the highlighted deck on firmware 1.2.

I use four decks and sometimes I can't tell if the signal to switch between decks is working. I have to learn the hard way when I accidentally hit the cue button for Deck A or B. I use Deck C and D to play all of my dj tools. I have battling this issue for the past 2 weeks.

Please help!

[Fow-T]

Hi Guys!

I have a problem with the 3.6.4 mapping and Traktor Pro 2.
When I simultanously adjust the Pitch and turn the jogwheel either in scratch or CDJ-Mode the BPM makes huges Jumps in the direction I push.

Example
Track BPM is 126
I pull the Pitch downwards and push the jogwheel clockwise
BAM-> New BPM now is 170

With Traktor Pro 1 and 3.6.4 mapping everything works fine. what could this be?

[JDT-NYC]

Go to the Controller Tab in Traktor, select the Tempo Fader command and on Interaction Mode change to "Direct." Repeat this for all your decks. I had the same problem about 2 weeks ago.

[Fow-T]

yeah that worked perfectly! thanks!!!
I changed even the commands commented with Slice and Echo to Direct - is that correct?

greetz

[Metrojolt]

Everything works great, but I'm getting no response from the crossfader and volume faders.

EDIT: issues was in my output routing, NOT MAPPING

[Pedrotax]

Everything works great, but I'm getting no response from the crossfader and volume faders.

EDIT: issues was in my output routing, NOT MAPPING

Yep, had the same problem, seems to be a default setting. Besides that, everything works well!

Good job

[fullenglishpint]

@Pedrotax, loving your sig

[BennyJ]

im on 1.3fw and im getting alot of lag and popping....idk what it is. i dont get it when i use tp1 tho

[fullenglishpint]

RAISE your latency. The total figure TP2 gives will be higher than TP1 because of the way it displays it. I forget which way round it is, but in TP1, one of the kinds of latency you see in TP2 was invisible.

EDITED FOR STUPIDITY