-
Two controllers with Traktor 3 ?
Hello,
I just bought the vci-100 and I have the Feena controller as well. I would like to use both controllers with Traktor 3, vci-100 for decks A&B and Feena for C&D.
Your time appreciated,Dj Chuy
-
-
DJTT Ninja Mod
I think he is also asking, how this could be done?
-
Tech Mentor
use seperate MIDI channels, e.g set the VCI to send out messages on channel 1 and the feena to send on channel 2.
This avoids any conflict bewtween the two devices. You can then assign your controls as normal in Tracktor.
-
i use two controllers. you don't have to use separate midi channels, just make sure your not sending the same CC number from different buttons.
-
Dr. Bento
Changing the channel is 99% of the time a sure fire way of not getting conflicting midi message - I use Midi-Ox to do this personally. Do the remapping in the data mapping section then apply it in the port routing window. I personally do this so i do not have multiple instances of Bomes open for each device.
-
i use 2 trigger fingers, identical devices on identical channel settings. so i had to change the channel for one of them..voila no conflict. total of 4 midi devices at a time.
-
-
So how to change the channel on VCI?
So is there any non-software translation way to change the channel on the VCI-100? I am quite keen on running 2 vci-100s
If not whats the best software for doing this on OSX? Midi-Ox seems to be a windows tool?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks