DJTT VCI-400 Ean Golden Edition Mapping (Traktor Pro 2)

[clearcut]

Hey, I just sent the same email to orders@djtechtools.com. Let's see what (if anything) happens.

[basspenetrator]

Hey, I just sent the same email to orders@djtechtools.com. Let's see what (if anything) happens.

cool. i added you to the vci400 facebook group. there are some discussions going on there too..

[akay a]

Why not also upload the firmware?

[Cyyraxx]

Mine will not scratch. Ive tried moving the touch sensor knobs around like someone previously said, still nothing. When i touch them it stops the track, but no job ability. Also is there a way to instanlty mute the loop decks, or do you have to just turn the knobs all the way down?

Also im not getting anything out of the master, I havethe RCA out 1 into my stereo and im not getting anything. I think i may have some setting off in traktor preferences because i have sound of all decks coming through my headphones and then when i que a track in my headphones its like it makes that track louder, or like its being played twice. Any help would be good

[photojojo]

Also im not getting anything out of the master, I havethe RCA out 1 into my stereo and im not getting anything. I think i may have some setting off in traktor preferences because i have sound of all decks coming through my headphones and then when i que a track in my headphones its like it makes that track louder, or like its being played twice. Any help would be good

Check your output routing

[Cyyraxx]

Check your output routing

I checked my audio and output settings everything looked fine to me. Im sort of new with traktor and dont completely understand the routing aspect of it. Can someone explain how it should properly be set up to allow me to que in the headphones and have the master come out the stereo?

Also upgraded to 2.1.2 like suggested in earlier posts, and then adjusted the sensor knobs again, but the jog wheels still will not scratch while in vinyl mode, just pauses the track until i let go of the jog wheel.

Any suggestions?

[Pistolpuma]

I have another question/issue. I don`t use vinyl mode. When I turn the jog wheel when the track is paused, it moves extremly slow. Is this just how it is? I am used to the vci 100 SE where I could change cue very fast this way.

[Cyyraxx]

I have another question/issue. I don`t use vinyl mode. When I turn the jog wheel when the track is paused, it moves extremly slow. Is this just how it is? I am used to the vci 100 SE where I could change cue very fast this way.

yea there is no way to seek quickly with the jog wheel, but what u can do is when the track is paused set the loop length knob to something high like 16 or 32 bars and move aroun in the track with the move loop knob. then get it where u want and press play.

[Cyyraxx]

Still no scratching ability, upgraded traktor to 2.1.2 and still nothing messed with the sensor knobs still nothing. someone please help me

[sidetrakd]

I have another question/issue. I don`t use vinyl mode. When I turn the jog wheel when the track is paused, it moves extremly slow. Is this just how it is? I am used to the vci 100 SE where I could change cue very fast this way.

shift + jog wheel moves through the track fast!

Still no scratching ability, upgraded traktor to 2.1.2 and still nothing messed with the sensor knobs still nothing. someone please help me

I had this problem. You need to map your jog wheels to scratch

Add in > transport > Scratch
Encoder Relative and then adjust your sensitivity/acceleration to suit