Hi all, This year i've been doing a GCSE Design & Technology project based around a case for a Kontrol S4 (or smaller controller). For my write-up I need a couple of short statements from potential buyers about it, so if you could say something constructive i'd be really grateful!
It is made of 1.5mm steel with a wooden lining with storage space. The lid is made of acrylic and slides back to allow access to the controller and act as a laptop stand. The lining has a small section at the front to allow for headphone routing, and the entire rear panel is removed to allow for cable-routing. Also, it would be possible to create inserts to fit smaller controllers, in case you don't have an S4.
Headphone hole
Cable routing
Misc. storage space
Toggle latches to hold the lid closed
Bookmarks