Hey guys, I read http://www.djtechtools.com/2011/09/1...ith-mastering/ (which barely touches on a lot of vital information to get the software working properly ) a couple weeks ago and have been trying to get Traktor to route its audio to Reaper (or any other VST host for that matter) to no avail. I tried to use Jack audio at first, as the article recommended but it was just too confusing. I then gave Soundflower a shot, which is another audio routing device like Jack, but just can't get the audio to come out on the end of Reaper. I have seen numerous guides on how to get Traktor to route to Ableton (which unfortunately I don't have) but have yet to see a guide for any other VST host. Could someone who has done this please explain how this can be done? I will even try to get a guide started, and hopefully someone can fill in the missing bits of information
- Download Soundflower
- Run Soundflowerbed (Not sure if Soundflower itself needs configuring or not)
- Run Traktor and click on preferences, go to Audio Setup and set Audio Device to SoundFlower (16 ch)
- Under output routing make sure Output Master is set to L: 1. Soundflower (16 ch) Out 0 / R: 2 Soundflower (16 ch) Out 1
- Run Reaper, go to preferences, Audio Device and select Soundflower (16ch)
That is about all I got, I know I am missing something, could any one who has done this before or is knowledgeable about it please help me fill in the rest? Thank you so much for the read.
Bookmarks