Hi guys, straight to the point:
does anyone know 100% if I could fit a Xone 1D in UDG producer bag?
I'm about to get one but I'm not too sure if the 1D will fit in it...
Hi guys, straight to the point:
does anyone know 100% if I could fit a Xone 1D in UDG producer bag?
I'm about to get one but I'm not too sure if the 1D will fit in it...
send a email to UDG or check out there forum if they have any.
Didnt think about that...I'll do it straight away!!!
Thanx for the tip Jesc
hey no problem.
A little bit of Googling never hurt nobody.
From checking different online retailer sites, it appears that the dimensions of the UDG Producer Bag are 10.5 x 7.5 x 19.
The dimensions of the 1D are 3.46 x 14.09 x 4.72 (converted from millimeters)
Going with the above specs, it appears that you'll have plenty of room.
Last edited by empolo; 07-09-2009 at 10:39 PM.
I measured the 1D but I think I was making a bit of confusion between centimetres and inches
Wicked then!!!
Sold!!!
Thanks Empolo
NP. One more thing...before you go spending $200 USD, take a look at a similar bag -->
http://tinyurl.com/l5bb98
$69 USD
I actually had my hands on this bag to hold my NI Maschine (which was just a bit too snug but did fit just fine at a 45 degree angle). This bag definitely has some hard core padding. It was a shame to send it back. I'd be very comfortable putting a 1D in it, no problem.
The dimensions of this bag are 12"W x 18" H x 8" D, well within the measurements of a 1D.
Last edited by empolo; 07-09-2009 at 10:58 PM.
i need a bag for my axiom 25, that thing is huge! (thats what she said)
|
Bookmarks