-
Filter knobs set to relative are not working properly - APC40
I mapped some knobs to adjust filter and because I did not want to have the knobs go to complete effect (resulting in silence) I mapped them with relative increments and set that to 60%. That way I cannot kill the track completely.
However, when I start Traktor, the range is often not -60 to 60 percent but -20 to 100. I then have to remap the knob before each session which is annoying. Any ideas what's the problem?
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks