Traktor 2: Delay/reverb into freeze

**phawsea** · 11-25-2012, 03:21 PM

Hey guys, I know I've seen this before but I can't find it anymore. I'm working on a mapping for Traktor 2 and my APC40 and I want to turn on the freeze button for the reverb and delay when the dry/wet-knob hits 100%. Does anybody know how this works? Best

**phawsea** · 12-01-2012, 10:18 AM

Is there no way to do this?

**dual citizen** · 12-01-2012, 10:20 AM

Originally Posted by phawsea

Is there no way to do this?

I could be wrong, but I think this is only possible if you mod the firmware to make the knob send a separate midi note when it's turned fully to the right. Bomes Midi Translater could perhaps emulate this?

**MWagner** · 12-01-2012, 10:36 AM

maybe possible if you set a modifier to kick in when you hit 100% and map the knob as a button for the freeze that kicks in when that mod state is triggered.

**phawsea** · 12-01-2012, 10:53 AM

Originally Posted by dual citizen

I could be wrong, but I think this is only possible if you mod the firmware to make the knob send a separate midi note when it's turned fully to the right. Bomes Midi Translater could perhaps emulate this?

ok thanks, i will have a look!

**phawsea** · 12-01-2012, 10:55 AM

Originally Posted by MWagner

maybe possible if you set a modifier to kick in when you hit 100% and map the knob as a button for the freeze that kicks in when that mod state is triggered.

yea i thought about that too. but i don't get how to map it. don't i have same problem with modifiers too? i mean, i can't really set a value of a modifier corresponding to a specific value of a knob.

**MWagner** · 12-01-2012, 10:59 AM

you can definitely set a modifier to kick in at various points along the turning radius of a knob. I've seen it done, but I'd have to play around with it when i get home to see exactly how it works. are you using a knob or an encoder for this?

**Stewe** · 12-01-2012, 11:11 AM

There's no need for modifier in that case. Setting button to engage when knob is at 100% should do the trick. This idea comes from DJTT VCI-100 custom mapping where flanger-pulse kicks in on fader FX.

**phawsea** · 12-01-2012, 11:12 AM

Originally Posted by MWagner

you can definitely set a modifier to kick in at various points along the turning radius of a knob. I've seen it done, but I'd have to play around with it when i get home to see exactly how it works. are you using a knob or an encoder for this?

i'm also trying out this right now but i couldn't figure it out yet. i'm using a knob. thanks!