DJTT Community,
I've been working out ideas on how to map the VCI-100 with the new features of TPro 1.2. I'll try to describe what I've implemented on my mapping:
FX ON/OFF FOR DECKS
I use a large button on top left to access a MOD state where the 4 small buttons turn on FX bank 1-4 for the deck in focus. I use one of the small knobs on top right to select deck in focus. This seems to work pretty well, as the red LEDs of the small buttons respond to changes in deck focus. As I scroll through the deck in focus, the LEDs show which FX slot is on for that particular deck.
EFFECT PARAMETER A/MAS/B
I have decided to do most of my FX tweaking on a separate controller (APC40/TouchOSC/nanoKontrol). As such, the default for A is to access Key Control. Each deck gets 1 key knob and a button to toggle key lock. Default for MAS is to access Loop Control. Each deck gets 1 knob to set loop size and a button to toggle loop active. Default for B is Deck Balance Control. Each deck gets 1 panning knob and a button to reset position. I can still access FX banks 1-3 by pressing the EFFECT SELECT V button while in A/MAS/B respectively.
SAMPLER
I will use the two buttons above the volume faders to access and turn on some sort of predetermined effect (DJTT TSI Sampler for example) which is set in FX4.
I like how I can access more functions from the VCI-100 and deal with FX on a controller that has more knobs and buttons. I'll put up my mapping soon. How is everyone else dealing with the changes?
Bookmarks