Native Instruments Maschine encoder pot 0B20K

[SlvrDragon50]

Encoders and pots are very different.

It has the same style as the S4 pot, but different design.

DjLiquitATL: If you can get me measurements of everything on the encoder I can look for it later. Dimensions of base, length of shaft, etc.

[makar1]

Yes, the function is different but the housing is almost identical. There don't seem to be any matching encoders on the Alps website though.

[DjLiquitATL]

Encoders and pots are very different.

It has the same style as the S4 pot, but different design.

DjLiquitATL: If you can get me measurements of everything on the encoder I can look for it later. Dimensions of base, length of shaft, etc.

I know how to solder and use a multi-meter...that's about as technical as I get...if this was a 1200 or analog mixer i'd be all over it...I've changed multiple bad pots on DJ mixers BUT never a encoder and never something that I have this much trouble locating the part for

i'll try to post specs in the morning...BUT i'm pretty sure its a 15mm shaft

[makar1]

Look at the spec sheet I linked on the previous page; it shows the proper way to measure the length of the shaft.

[SlvrDragon50]

Yea. The datasheet will show you how to measure everything properly.

You just need a pair of calipers.

I really don't understand why NI is so anal about not selling parts. They already have a sticker over a screw for tamper evidence..

[makar1]

Because it costs <$200 to build an S4 from scratch

[DjLiquitATL]

I give up on the search for the encoder. Going to send to NI for a new/refurb unit for $140.00

[SlvrDragon50]

Ack. If you send me the dimensions I"ll hunt it down for you!

Or you can mail it to me if you don't have calipers.

[Ross]

I give up on the search for the encoder. Going to send to NI for a new/refurb unit for $140.00

Have you actually taken it apart though? Because that's definitely a warranty voidage.

[SlvrDragon50]

Warranty voidage = you pay for repair

They'll still work on it.