Hello,
I got the Traktor S2 controller a few months ago and have got my first DJ gig. Any tips to give? Strictly sync button and music during the first gig and play it safe?
My setup is Traktor, Traktor S2, laptop.
Hello,
I got the Traktor S2 controller a few months ago and have got my first DJ gig. Any tips to give? Strictly sync button and music during the first gig and play it safe?
My setup is Traktor, Traktor S2, laptop.
I don't think sync matters when you can put the tracks at the same bpm so accurately anyway. There isn't much that can go wrong. I find with my tracks the sync is out a bit more often than not anyway when I'm using traktor (which is rare).
Just DJ how you DJ. IF your tracks are prepped enough then sync if you want, but if they're not, are you comfortable using the jog wheels to correct them there and then in the mix? If you're not, then you shouldn't take the gig.
Since you're going to go and do the gig anyway, and presuming you're running the S2 into a mixer, I would have another source of music, anything like a CDJ or even an iPad with a pre-recorded mix on that you can just throw into the mix if your Trakor decides to go bananas in the middle of a gig. Always remember:
"If it CAN happen, it WILL happen". There's no downside to being prepared for the worst.
Also, remember you're playing for a crowd, know beforehand what kind of music they're likely to want and then judge on the night how far within that musical boundary you can push.
Kontrol S4 ★ Senn HD 25-1 ★ Kontrol F1
You did not give any context about the gig...club, something else, who is providing the gear, event type, audience size & age, other DJs, etc. Those details matter...but I can still offer some general advice.
A song is played for about 3 minutes...you can average about 20 songs per hour. That is a good number to use for planning. I would prep about 30 songs for each hour of the event. Double check the load point, the bpm, and grid. Listen to these songs so you can recall the details - intro, lyrics, breakdowns, loop points, mix in/out points, etc. If needed, set some cue points, or loops...depending on how you want to use that song in your set. If you have to do a handful during the event to handle requests...that's easy...having to do half the songs you are planning to play, that's stress you do not need.
Know what EVERY BUTTON on the S2 does. Every single one.
Setup the laptop, controller, and whatever else you are thinking of bringing....play some music. Then pack EVERYTHING you just used into your gig bag. Ask what the connection to the mixer is, and make sure you bring TWO of that cable. In fact, having TWO of ALL the cables is not unreasonable.
Have some backup music ready to go. This can be a couple AUDIO CDs, a playlist on an iPhone (in airplane mode...no calls during your set), or even a thumb drive (if you are bold and know EXACTLY how to use that on the system at the gig). There is a GOOD chance you will need to use this when transitioning from one DJ to another (if there are multiple DJs playing...you didn't say).
Eat a meal of REAL FOOD 1-2 hours before the gig starts. No junk food. No caffeine loading. No sugar loading. ABSOLUTELY no alcohol (or anything else).
Show up early. You would rather stand around for 30 minutes ready to go, than be even 1 minute late. Setting up in a rush is stress you do not need.
KISS (Keep It Simple Stupid). Play slightly conservative...stay within your comfort zone...both in terms of song selection, and mixing. Resist the temptation to get fancy with your mixing or effects. Less is more. For your first time out, a solid set that shows mastery of the basics is MUCH better than anything else. If nothing else, this will help to reduce your stress...and it may even give you some time between transitions to look out and see what is happening in the room.
Look at the room. Watch the people who are dancing on the floor, tapping a foot in the chairs, maybe singing along, etc. Also, try to find anyone who looks bored or like they are not having a good time...then change their mind.
Finally, remember to take a few moments and notice that you are having a good time.
Denon X1600, NI X1 Mk1 & Mk2, MF Twister
Kontrol S2, Maschine Mk1, APC 40
Retired: VCI-100 Arcade (Signed #198/300))
BFM 10x DR200 & 10x Titan 39
Don't know if it happens with S2 but I was on one of my first DJ-software-gigs with an S4, I pressed "Browse" then deck's "Cue" and the sound stopped completely. My friend pushed some buttons and I could play again. That was embarrassing. I don't really know what I did and I don't play with S4 or softwares now so I don't really need to know anymore, but I wouldn't do that if I were you...just in case...
Anyway, create some procedures for mixing, browsing tracks, beatmatching, etc. Don't panic and start pushing buttons on combinations you never did before because it can end bad.
As others already said, having a pre-recorded mix is a good idea.
Fear is a good thing, use it for your own benefit.
13" Macbook Air i7, 8GB RAM, 512GB SSD | Traktor 2.7.1 | Ableton Live 9 | DJM-900 Nexus | NI Audio 10 | A&H Xone:K2 | Oyaide USB & RCA | HDJ-2000 | Odyssey BRLDIGITAL Bag
Just my personal input, something I did right before my first gig...
Set your Traktor settings to make sure you can't load a new track into a deck that's currently playing. Saved my ass enough times.
Last edited by JZed; 01-28-2014 at 03:45 PM.
I can't believe I haven't done this yet, guilty of this on a few occasions, mostly alcohol induced.
settings>loading>load only into stopped deck
Last edited by bisco; 01-29-2014 at 12:40 PM.
Bump.
Has the gig happened yet?
How did it go? What did you learn that you want to pass onto the next person who asks this question?
Denon X1600, NI X1 Mk1 & Mk2, MF Twister
Kontrol S2, Maschine Mk1, APC 40
Retired: VCI-100 Arcade (Signed #198/300))
BFM 10x DR200 & 10x Titan 39
Xone DB4, Technics 1200 MK5 x2, Technics MK3 x1, Serato SL1, Novation Dicers, Sennheiser Adidas HD25
Always uploading new mixes to https://soundcloud.com/djskullduggery
|
Bookmarks