Stanton St. 150 problem
Results 1 to 2 of 2
  1. #1
    Join Date
    Jan 2014

    Default Stanton St. 150 problem

    Recently, one of my St. 150s has started to have a slight delay when starting and stopping. It usually takes well under a second, but now takes almost 1.5 seconds and appears to be kind of winding up when starting and slowing down gradually when stopping.

    Upon inspecting the turntable I noticed that the spindle is significantly looser than on my working turntable and appears to be encountering a bit of resistance in one area (it feels and sounds as though it's rubbing against something). I've looked into it on the internet and contacted Stanton, but it appears that this is not a widespread problem and therefore there is not a well known cause and solution.

    Does anyone here know what could be causing such a problem and if there is any way to fix it? Has anyone else at least experienced something similar ? Any help at all would be greatly appreciated.

    Thanks in advance.

    Also, this is my first time using this forum and I'm not sure if this is the right place for this, so I apologize if it's not.

  2. #2
    Tech Student
    Join Date
    May 2012


    There are 2 knobs on the controller which ajust the startup and slowdown of the platter. Make sure you have set those correctly.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts