Hey, guys!
In my current set-up I've got a Traktor Z2 and an Audio teknica LP120 running with a timecode vinyl running.
I keep getting a red "low input"-signal flashing when I try to calibrate my record. this happens basicly everytime I open up Traktor. Earlier, what I've done is brush my fingers on the needle and brush the dust of off the needle in order to get a cleaner signal and then everything works fine. However, now it doesn't seem to work. The audio is sounds very distorted and above the deck inside the software it says "Low Input". What am I doing wrong?
Screen Shot 2017-06-18 at 15.12.07.jpg
In case this is relevant:
The turntable is plugged into line. (not phono)
The turntable itself is set to line. (not phono)
I have not used the metal screw thing to "ground" the signal or whatever. I don't know what that's for.
I'm using the cartage that came with the turntable.
Bookmarks