Rekordbox DJ Kontrol X1 mk2 help needed!

[ataxel]

Thank you, those are written by default when using the learn button.
Still not working but I will try hard cause I really need that feedback.

If you have any other ideas ( I also asked on Pioneer Forum ) that would be nice.
If not, thank you anyway

Lp (*

[the_bastet]

Thank you, those are written by default when using the learn button.
Still not working but I will try hard cause I really need that feedback.

If you have any other ideas ( I also asked on Pioneer Forum ) that would be nice.
If not, thank you anyway

Lp (*

Mos definitely. Another work around is to open the mapping csv in either excel or notepad++ and ensure tha velue are correct.

[MaxOne]

Not sure this is exactly relevant but I worked out a bit of mapping issues with X1mk2 and RB with controller editor.

I was just trying to get the play buttons to light up and stay on when the deck is playing.

It took a fair amount of figuring out but basically it's all about how you configure NI Controller Editor and making sure the knobs are set right.

Type > Control Change (not note)
Mode > Toggle
Value > off = 1 on = 2.
Action = Down
Also another thing to note, the way the midi is displayed in RB is in HEX eg B02C . The way it's displayed in Controller Editor is Decimal eg CC 44.

You have to use a HEX to DECIMAL convertor to work out the corresponding numbers BUT you have to drop the first letter / number (either 9 or B) from the HEX midi.

So using the below website put in "02C" instead of B02C and you will get 44 which will be CC 44 in Controller Editor.

https://www.binaryhexconverter.com/h...imal-converter

Then you can play with Mode eg Toggle / Gate depending on what you're trying to achieve. Also, for some button mappings, to get the LEDs to work right, you need to change the drop down in LED to Midi Out.

Ive been tearing my hair out with this so hope it helps someone!

[Stewe]

Not sure this is exactly relevant but I worked out a bit of mapping issues with X1mk2 and RB with controller editor.

I was just trying to get the play buttons to light up and stay on when the deck is playing.

It took a fair amount of figuring out but basically it's all about how you configure NI Controller Editor and making sure the knobs are set right.

Type > Control Change (not note)
Mode > Toggle
Value > off = 1 on = 2.
Action = Down
Also another thing to note, the way the midi is displayed in RB is in HEX eg B02C . The way it's displayed in Controller Editor is Decimal eg CC 44.

You have to use a HEX to DECIMAL convertor to work out the corresponding numbers BUT you have to drop the first letter / number (either 9 or B) from the HEX midi.

So using the below website put in "02C" instead of B02C and you will get 44 which will be CC 44 in Controller Editor.

https://www.binaryhexconverter.com/h...imal-converter

Then you can play with Mode eg Toggle / Gate depending on what you're trying to achieve. Also, for some button mappings, to get the LEDs to work right, you need to change the drop down in LED to Midi Out.

Ive been tearing my hair out with this so hope it helps someone!

Very solid advice MaxOne. Thanks for sharing it!