Hello everyone!
I'm sorry if I write in wrong section of the forum.
I've recently purchased a used DJ controller, Reloop Contour Interface Edition. Guy who sold me this unit tried to update firmware to v13 but during installation computer unexpectedly shut down and failed to complete update. Operating system (Win10) is now recognizing the device, I can see it in the device manager, and the driver is installed without any problems. DJ software (Traktor 2) is seeing the MIDI controller I/O and all sound outputs (Reloop ASIO driver) is working fine but all buttons are not responding at all. I tried to update firmware again, but unsuccessful, because software provided for updating firmware does not see the device at all. I followed instructions but somehow the CUE (press and hold then power up device) button do not respond. Buttons 1,2,3,4 and A,B,C,D as well as knob buttons Dry/Wet, Fx. Param. 1,2,3 light up but the rest of the controller does not put out LED lights on any button, nor the button respond. Since the product is discontinued I cannot find any similar problem on the Internet so I'm writing to you in hope that you might have some guide which can lead me to a problem solution.
I wish to thank you in advance for your time.
Thanks,
Hexov
Bookmarks