Traktor Kontrol X1 rotary knob mapping assistance
Results 1 to 3 of 3
  1. #1
    Newbie
    Join Date
    Feb 2021
    Posts
    2

    Default Traktor Kontrol X1 rotary knob mapping assistance

    Hey team,

    I recently opened up my x1 and replaced a broken rotary knob, this was successful. However have two small mapping issues now.

    1. The rotary knob is invert. So turning it forward moves it back.
    2. The rotary knob requires two 'clicks' forward or backwards to have a response on Traktor. I have tried adjusting the rotary sensitivity and acceleration, these are different.

    I have tired remapping the knob with invert on, this works however there are so many other commands/modifiers connected to the rotary knob when I do this I lose them all because of the "override factory map" if someone has another way to invert this without losing all other commands that would be great. Or even the default file that shows all commands for the rotary knob in the assignment table, then I could copy it all with invert on.

    Thanks

  2. #2
    DJTT Mapping Ninja Moderator Stewe's Avatar
    Join Date
    Aug 2010
    Location
    MIDI
    Posts
    7,460

    Default

    Sounds like the new rotary isn't the same type. You need to find an adequate replacement in order to get all factory mapping functions.

    The resolution on NI's knobs is the best. It sounds like that knob has a half less ticks per revolution. Fader-Direct mapping cannot resolve that issue unfortunately.

  3. #3
    Newbie
    Join Date
    Feb 2021
    Posts
    2

    Default

    ah right, yes it was a different rotary knob. I got it off eBay. Can you recommend a credible online shop that sells the correct rotary knob for the X1? Thank you

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •