[Ableton] Midi Twister - Controlling different knobs when encoder pushed down
Guys,
This must be possible but I’m stuck. I want to map a midi twister know to control two different software knobs in Ableton depending on whether the encoder is pressed down or not.
I understand the effect of the encoder push needs to be configured for each knob in the midi fighter utility, but none of the options result in a what I want
Regardless of whether the encoder is pushed down or not, when I twist it Ableton receives the same midi information.
(to be clear I tried “shift encoder hold” and “shift encoder toggle”, however twisting the encoder seems to send the same cc code regardless of the shift toggle?)
You my friend have saved me a a fair amount of stress, I was scouting the net for a solution and after about 2hrs and countless YouTube videos and questioning my sanity your solution worked wonders so thank you [quote=“doctorg, post:2, topic:78126, username:doctorg”]
A factory reset solved the problem…
A bit disappointing I needed a factory reset on a new unit though.
[/quote]
I had exactly the same issue…
new unit…updated firmware…
shift encoder hold/toggle were not working - still sending out on ch 1 regardless of whether the encoder was held/toggled.
Did a factory reset and then it worked.
I agree, this should not be required on a brand new device.
