Anyone have any tips on getting the rubber bumper of a mf?
Cuz I could use one. Or a few.
I feel like I’m gonna snap the boards.
just ease it on gently like start by hooking the back part of the cover into place the ease it on gently coming up from the bottom of the mf with a little bit of gentle stretching it should fi on snugly
Do you want to put more bumpers on or take them off? If you want to put some on check walmart in the hardware section by the picture hanging stuff. I saw some in there the other day.
I totally forgot I posted this. Thanks for the replies guys.
I’m talking about removing the silicone case.
Hey Chilly - the easiest way is to undo the screws.
You can remove the silicon case without undoing the screws but it puts a lot of stress on the PCB so I would not recommend it
Thanks! Makes perfect sense now…
Just what I was going to say. The youtube vid makes it look easy but it’s a right pain!
it’s definitely a pain. i cracked the corner of the bottom plate in the process of removing the silicone case.