apc40 activate,solo,arm as effect unit on?

DJ Software & Apps Controller Mappings
1

apc40 activate,solo,arm as effect unit on?

hmmm… it doesn’t toggle correctly. any ideas?

current behavior:
no led= effect off
push button to activate unit = led is on = effect is on

push button to turn off unit = led off = effect unit on
push button again = led on = effect unit off
push button again = led off = effect unit off

uh?
shouldn’t it simply be off = unit off and on= unit on?

2

so yeah… it has to be set to hold instead of toggle… any ideas why?

3

You have the APC in dumb mode? (open up ableton to get the red box around the clips. Then close ableton (all lights go out on your apc40), thats dumb mode.
Then the hardware toggle buttons dont mess up your mapping in traktor.

I have my apc’s mapped for dumb mode, works like a charm!

4

I had this same issue. The problem is that those buttons are hard wired as toggle buttons. So even when you set it to hold it acts like a toggle because of the way the APC is hardwired.