BCN44 (behringer nano control)
Help! Can someone explain me how to map the bcn44 from behringer with traktor pro?
The same way you map anything else. The traktor manual has a super good explanation that’s really easy to understand. Open it up and get stuck in! 
How are you pluging the bcn44 into your computer?
Are you using MIDI → USB cables like those bellow?
I think he’s doing it like these guys
This picture was epic! lol!
they look soooooo intense as tho they’re really into what they (arent) doing too 
definately a bit of an air dielectric between their controllers and laptop 
I’m using a Midisport 2x2 and I can see the BCN44 sending signal to the interface but Mac OSX don’t receive it (I’m using AudioMidi from SnowLeopard to check it).
It’s true that I can not use the midi interface and USB powered controllers?
just to double double check you could try running the “dump” from this dmg image http://midimasher.djism.com/downloads/midimasher-20120223-mac.dmg
there’s no power going thru that adapter so you’d need to use a usb power cable for usb powered controllers - but surely they wouldn’t need a usb/midi adapter anyway? unless u don’t have drivers for them i guess.
I always wanted one of these - they’d be awesome for track selection/mouseless navigation…
Same here. I’m looking at the new behringer controllers for a low cost solution at the moment, assuming xwax ever gets midi support
If the mapping works the same as on the BCR2000, you should first make sure there is a preset configured on the device itself.
If that’s done, you will have made sure that the Behringer actually sends out a MIDI signal and the mapping the MIDI in Traktor can begin.