BCR Overlays
So I ordered some of the plastic overlays for my bcr ( http://www.lexplastics.co.uk/ ) and they are a bit warped. They do not fit perfectly and sort of “pop-up”. I have had them on a flat surface under about 30lbs of weight for a couple days now to no avail.
Anybody else had this issue? Anybody have a success story?
You can always glue them with one-secondglue.
Sorry man, I always have shunned away from these things.
If I use anykind of overlay, it’s just maskingtape. No more, no less. 
Yeah, I got them too and was a bit pissed off at the poor quality at firts.
Trick is to roll the overlays in the opposite direction with quite a small curve but without getting folds offcourse.
I got them pretty straight, but still use a few bits of tape to keep them in place.
They do work this way, and sure beats masking tape if you switch regularly.
Hope this helps 
Hey dont talk too much smack about overlays
ours rock! But they are OEM quality and not the plastic variety that most people usually make.
Wanna do an overlay for BCRs Ean?
we should- that could be fun.
Cool, will look if I can find a hires image/illustration of a BCR tomorrow @work.
@ Tekki
lost whats a bcr?
runs for the door
~shakes fist at JesC~
GRRRRRRrrrrrrr! 
http://www.lexplastics.co.uk/Bcr%20overlay%201.jpg
I would have no problems with designing it if I could get one for free! 
Will see what I can make of it this afternoon.
there are overlays to print out on the behringer site.
and you get a professional overlay for your bcr!