Cross Fader Mapping…
G’day DJTT First off I searched on here and Googled it. What I’m wondering is how do I momentarily stop my cross fader from moving. Here’s the back story… I’m mapping my X1 So I can command pretty much all of the functions for two decks, problem is I have run out of knobs so what I was wondering is how I use a modifier to turn off my cross fader and turn on a filter and use the same knob to control either.
TL;DR How to turn off my cross fader.
Thanks guys…
It’s been a while since I’ve used Traktor, but I think something along these lines would work:
Assign a button to be your “shift” key. Have it toggle one of the modifiers between 0 and 1 for to make it an on/off button.
Set the controls you want to be toggled to have that modifier as a condition.
Make additional controls using the same button/fader/knob and set the same modifier as the condition at a different number.
Somebody correct me if I’m wrong or unclear. 
Use hold function to make as momentary shift.
but how do I set the cross fader to 0???
If Modifier = 1, Cross fader = 0 there for if Modifier = 0 cross fader = 1
but the cross fader cannot be controlled by an on/off switch can someone explain further please.
haha! dont worry guys I just worked it out
thankyou so much for the help.
There is no crossfader on an X1
but there are knobs that can be mapped as such.