I was trying to copy the fader FX mapping of the VCI 100 SE for any controller and this is what I came up with. This tsi was the best I could do without special firmware. It turns effect 3 on when effect 2 is at value 93%.
But the problem is. When I move the fader slowly, it works alright but when I move the fader too quick it does’nt work. But maby this is because I am using an old crappy Hercules DJ Console MP3. I don’t know but maby it works better with better controllers.
Could you please test it for me and tell me if it works better on your controller ?
If it doesn’t work at all, you may have to change the rotary sensitivity of the modifier i used.
ATTENTION :
1)This is not a tsi for a full controller. It only tries to copy the volume fader of the VCI 100 SE in fader FX mode
2) You have to map all the controlls to one fader using midi learn.
Thanks brother I’ll give it a try if I can get it to work either as you state or tweak to give a little better response I’ll try to add it to my new Numark TC mapping. I’ll be sure to mention where I got it thou
I did this on a VCI-300. I had to invert the commands as the fader FX was working from top to bottom. I messed around a bit, tried a few different things, it effect 3 was turning on sometimes at the bottom other times it wouldn’t…then effect 2 would not turn off. Ultimately I think I just raised the sensitivity a bit and it’s working great. Gonna use this on the VCI-300 mapping being worked on. You sir, are a pimp Great job!
i say it’s a 90% solution. There’s a few times effect 3 stays on when go to fast. Or it comes on a tad bit early. Maybe this can be played with a bit. Having had a VCI-100 previously I will say it’s close to Fader FX on an SE, but really if you have room for modifiers to work this into your TSI, it’s better than not having it at all.
hmmmm weird. I am using the mapping on one of my Akai Mpd24 faders and it works perfectly. Whenever i reach 93% of the value, the second effect turns on; i even tried movin the fader realllyyyyyyyyy fast and still had no issues so far.
Dis anyone test this with the faders of an Akai APC 20/40 ? I was thinking about buying one of these but only if the fader fx works properly. And it seems it works pretty well on Akai controllers, if I read the previous posts.
Not all controllers will react in the same way.