dnb is my first love and i have only played dnb on vinyl. i just recently got traktor and a vcm100 and have been playing around with it with house and pop songs. yesterday i went to beatport and bought a few dnb tracks to throw in traktor. i have gotten most of them beat gridded but i have one song that i’m having problems with. traktor is reading it 130bpm of the bat. the bpm setting is at 70-190. i have adjusted it just a little up and down, but it is the same deal no matter what i do. any suggestions?
also on another note. how can i get the tempo fader more acurate? i’m also having a hard time beat matching just usng the tempo faders. what percentage should they be set at for this? this style of mixing is way different that traditional vinyl. they are both fun. thanks in advance people.
i would if i could. vcm100. i really hate using the sync button. although i use it when messing around with other songs. but you know, dnb is different. hehe. it deserves better than that. dont worry about it. i was just trying a few dnb tracks out out. i haven’t converted my dnb record collection to mp3’s yet. if i can’t get this figured out i most likely wont. it would take months anyway.
Don’t be afraid of the sync button, as long as you know how to beatmatch manually - just in case, you know
I’m kind of in a similar situation. I used DJDecks and Traktor Scratch Duo for a while now, bought about 1000 tunes in different stores, didn’t care about beatgridding for some time. It’s kind of useless if you use it with control vinyls. I had a Numark Total Control and didn’t like it for it’s really plastic cheap feel and unprecise pitch faders. I just got myself an Otus, and it’s a lot of fun.
As far as the beatgridding is concerned, traktor has a hard time with breakbeats, so there are always going to be a few tunes it doesn’t detect properly. Setting the BPM range to something like 155-190 helps a little, but for some tunes that’s just not enough. You’ll need to beatgrid manually, there’s no other way. It’s a hassle, especially if you need to do it with more than a handful of tunes. It does pay off though, as you need proper BPM values and sometimes proper beatgrids for the effects to sound good. Not to beatgrid properly means you just can’t access the full potential of traktor.
By the way, I did map a sync button. For now, I stick to beatmatching manually to get some practice in how to do it with this piece of kit.
Traktor does not do the best with d&b, I would just set a grid marker on the first well defined kick ( on a 16) and then manually set the tempo to about 174 and then adjust the track tempo until the 4th marker past the grid marker is on the kick.
I DJ Dnb also and I found that with some tunes it can’t get the bpm correct. I usually set the bpm in the settings to 168-180 as dnb is very very rarely higher/lower than that. As I said some tunes it will get wrong. A good way to double check is to go on chemical-records.co.uk this will tell you the bpm of most tunes, but again this is not always accrurate.
