How to Blink Track End Warning

DJ Software & Apps Controller Mappings
1

How to Blink Track End Warning

What I need to change here

Untitled.jpg
Untitled.jpg209×280 12.1 KB

to blink track end warning.

Thanks

2

I think you don’t here, the led output is 0/1 . It’s not a blinking message.
Blend ticked is not necessary as it’s a two way messages only (on/off).

3

So what I need to do

4

Track end warning is not defined with blinking LED state, instead it send just on/off massage as Yul said. I saw this question before. How I managed this to work is to set modifier (with output) and beat phase (with it’s ModCon) on same button where your end warning LED is mapped. When track reach end zone LED switch on (normally) and then set modifier to value 1 (or whatever) and then blink become activated. But. It worked well for my bcd3000 but this other guy couldn’t make it to work on his controller.

5

I will try modifier 2 (value 1).

6

I tryed and created two Track End Warning LED. First LED mapped to Ch2.CC.42 and Modifier Condition is MF1=0. Second LED mapped to Ch2.CC.42 and Modifier Condition is MF1=1. And I assigned Modifier#1 to a button. What am I doing wrong. Should I create another Modifier with different settings.

Thanks in advance

7

You don’t wanna use 0 for modifier condition because 0 switch of LED and you need modifier LED output to lite up. Instead of 0 use any value 1-7 which are LED positive. In that case you’ll need to set two direct modifiers for each end warning (M1=1, M2=1).

8

songpos_remain 30% ? blink 400ms : off

:stuck_out_tongue:!

9

Yep, that’s easy in VDJ. Still waiting for Traktor global beat monitor output.

10

Should I need to assign key for M2.

11

Yes, if you want to use it obviously :slight_smile:

12

Here is example for deck A:

Add in / Modifier 1 / direct / value 1
Add out / Beat phase / ModCon M1=1
Add out / End warning time

Everything mapped to toggle button.

13

Last question about mapping modifier#2. Can I map MF2 to MF1(Shift Button).

14

No modifiers 1 and 2 need to work separately for each deck.

15

Any luck on this?

16

I have no time to test it this week. I’ll let you know when I do it. Thanks for your interest.

Best Regards

17

It didn’t worked. I created two output for track end warning. First one M1=1 ch2.cc.42. Second one M2=1 ch2.cc.42.

18

You mapped both deck’s end warning to one button ch2.cc.42? you need to use two buttons - one for each side.

19

No ch2.cc.42 is the track end warning output. M1 is mapped to ch3.cc.05 and M2 mapped to ch3.cc.30.

20

Take modifier 1 and map it to ch2.cc.42 where your end warning deck A is set and take modifier 2 and map it to some other button for deck B.