So I jumped on the S2 bandwagon, and am trying to get it setup. It took multiple installs of the drivers to get all of the controls on the S2 functioning (only deck A was working at first, and the looping buttons and encoders did nothing). I could swap the gain control over to a filter via the S2 heading in settings and had it working as a filter, however when i have my X1 plugged in as well, only gain works, even tho filter is highlighted in the settings, and even when i use the shift button, I can only control gain.
Also, the orange triangle on the unit is continuously flashing, and i cannot seem to figure out why.
Can anyone share some insight into my situation. I would much rather use the gain knob as a filter, rather then gain. And would like to know what this orange light is all about.
I figured this would have been a more straight forward install since im using 2.1.2 and a macbook
The orange light can be the overall volume is to low, possibly track end warning? I dont use the standard map so I cant remember exactly what makes the light flash, is it flashing? Maybe restart the macbook and see if it behaves.
Does holding shift while using the gain nobs make the filters work?
I have tried to hold shift plus gain, but that still only controls gain
I would really like to get this working for the filter, even tho the clickyness of it is less then ideal.
The orange triangle seems to have stopped flashing
When the triangle is flashing on my traktor s2. I just plug in my laptop charger and it goes away. Its like a battery symbol for me. No charge plugged in = flashes. When i plug the charge in, goes away. Try that.
thats probably what did it, my battery was running low, now that i have it hooked up to the charger its all good.
Still would like to have the filters working tho. I’ve restarted the program a few times, swapped between filter and gain control with multiples restarts, but no such luck.