I posted this in general with not much response so I’m trying my luck here.
“I am running the native Kontrol F1 mappings (for remix decks) in addition to Tekken’s F1 Ultimate F1 mapping. I find that swapping between midi/native mode is unreliable with shift browse. Sometimes it works, and sometimes I can only swap between the Tekken map and some random page where all the buttons are blue and the digital readout goes “-”. I have difficulty returning back to the Native mapping so I can control the remix decks natively”
Another poster on your Mapping thread also posted this: “Wow what a great mapping but im quite annoyed at a particular element of it last night i was jamming and i pressed shift and browse and that allowed me to control deck a and c with 8 hot cues spread across the 16 buttons going down vertically for each hot cue? please dont tell me this is a glitch as id like to use it again as i prefer launching hot cues that way than with the s4’s dedicated cues please reply soon thanks alot, Zayd!”
Which is similar to what I experienced. I discovered that if I press shift and browse it will enter this all blue button mapping (with 00 on the digital read out). When I looked at my controller mapping it turns out it is under " Traktor: Kontrol F1 (User)". When I delete the mapping or change the “in port” the mapping will disappear. However if i keep pressing shift+browse it will show up again as if its built into the controller.
Where did you get the “Traktor.Kontrol F1.User” mapping? After importing my .tsi? Did you do step 4 of my manual? This user mapping shouldn’t be in the controler editor.
”