Mapping for Noobs!

DJ Life & Community General Discussion
1

Mapping for Noobs!

Ok, so after some feedback and guidance from other forum members, I decided to take the best mapping I could… and simplify it! It could be the Aussie thing but rather than build.. I almost demolished.

Most of you would probably be embarassed by my first attempt but my mapping does this:
Deck Selection
Play/Pause/Stop
A few effects
8 Cue Triggers
All in all it’s basically what I want.

I do have a few issues I would like help with:

  1. I use the bank select buttons to pick a deck in the following order: C A B D
    The actual deck selection works fine but I just cannot get the lights on the buttons to work properly. They either light and don’t turn off or don’t light at all. It would be great to have a quick look and know what deck I am controlling. When finalised I would like these buttons to select the deck, activate the cue through my headphones and light up… so any guidance would be appreciated.

  2. Somehow I “deleted” parts of the Freeze Delay effect… if anyone can give me some advice on re-mapping that affect it would be awesome.

I will upload the mapping once I have tested it more and, hopefully, solved the above issues with the assistance of other forum members.

Coops

2

Here is for Echo-out effect:

Add in > FX Unit > Effect Selector / type-button / mode-direct / value-Delay
Add in > FX Unit > Unit On / type-button / mode-toggle
Add in > FX Unit > Button 2 / type-button / mode-toggle
Add in > FX Unit > Button 3 / type-button / mode-direct / value-0
Add in > FX Unit > DryWet / type-button / mode-direct / value-0.300
Add in > FX Unit > Knob 1 / type-button / mode-direct / value-0.600
Add in > FX Unit > Knob 2 / type-button / mode-direct / value-0.400
Add in > FX Unit > Knob 3 / type-button / mode-direct / value-0.300
Add in > FX Unit > FX Unit Mode Selector / type-button / mode-direct / value-Single
Add in > FX Unit > FX Store preset / type-button / mode-Trigger

Could you upload your TSI mate? I could give a peak and give some feedback because I’m not quite sure what could be wrong there by looking in your input on a LED issues.

3

@ Stewe - Thanks again. Uploading now. It’s called Map for Noobs.
Haven’t had a chance to add that effect yet.
Let me know what you think.
Coops

4

Noobs Map

Decided to put it here instead of uploading to maps… nowhere near ready for others and would appreciate a double check first.
Coops

5

Mate, first thing remove all the modifier values except for ‘FX Panel Mode’ from condition 1 and 2 slots. Clear all commands off modifiers and re-upload. Some of commands you have taken from IG mapping are still set to work with a modifiers but you got that modifiers deleted while editing. And I’ll add echo. That goes M8 if I’m correct.