MF PRO HELP Please. access midi message that kicks in half way thru the rotary/fade
Just stumbled across a small issue I can’t find an easy answer for. I’m just getting in to the second push of making my own take on the IG map and stumbled across a little issue. As most will know the MF Pro (Cue Master, I’m using) pots send a number of different messages. The midi message I’m having issues with is the one that kicks in from the 12’o’clock/half way position. All the other messages from the pots work as you would expect but the minute I assign, for instance,
CH03.CC.017+CH03.CC.016, to a control
it then has conflicts with controls mapped to
CH03.CC.17
CH03.CC.16
CH03.Note.F7
CH03.Note.E7
All controls mapped to the four messages above seem to get over taken once CH03.CC.017+CH03.CC.016 gets involved. I say taken over as both Note messages fail to work and the CC messages mapped to rotarys will only partially turn the controls.
I’ve created a blank mapping to troubleshoot and the same problem occurs, for instance I map CH03.CC.17 to “effect 1 amount” and CH03.Note.F7 to “effect 1 on”, all works fine. But then if I map the message CH03.CC.017+CH03.CC.016 to a completely different control like “Deck A Filter”, it then does what I’ve previously described, meaning “effect 1 amount and on” do not function properly any more, grrrrrr.
I’m guess I’m missing something here, please let there be a work around!?
Good question! In the case you are describing on the MF Pro CM, when you are trying to “learn” the secondary Super CC command, Traktor tries to combine both the secondary cc and the full range cc incorrectly. In cases like these you often need to manually set the Midi CC for the command rather than using Midi learn. So to map just that secondary cc, you will want to map Ch.3 cc17.
I’ve also attached a really jenky visual layout of the Midi commands that I made a long time ago when making the MF Pro mappings. At some point I’ll make this into a clean digitalized picture but for now it could help a bit.
