# Midi Fighter looping problem with Utility
**URL:** https://forum.djtechtools.com/t/midi-fighter-looping-problem-with-utility/76886
**Category:** General Discussion
**Created:** [January 23, 2018, 1:41pm UTC](https://forum.djtechtools.com/t/midi-fighter-looping-problem-with-utility/76886 "2018-01-23T13:41:37Z")
**Posts on this page:** 2
**Page:** 1
### Author:  [@BeatMachinery](https://forum.djtechtools.com/u/BeatMachinery)
#### Post date: [January 23, 2018, 1:41pm UTC](https://forum.djtechtools.com/t/midi-fighter-looping-problem-with-utility/76886/1 "2018-01-23T13:41:37Z")
**Midi Fighter looping problem with Utility**
Hello!
I just recently got my midi fighter twister but I keep getting problems with the utility. Problem is that when I connect the Twister , the screen tells me “Connect a midi fighter twister” and suddenly , the screen changes to the editor mode but then it quickly returns to the “connect the midi fighter twister” and it keeps doing that again and again , like a loop…
I´ve tried to install other versions of the utility and it is the same. I´ve also tried to connect the twister into a direct usb port and also by HUB and nothing…
Im using windows 10 on a PC and also I have a Novation lunchcontrol and an AKAI APC40 connected at the same time , could that be the problem?..
I would appreciate your help! Thanks!
---
### Author:  [@Stewe](https://forum.djtechtools.com/u/Stewe)
#### Post date: [January 24, 2018, 3:40am UTC](https://forum.djtechtools.com/t/midi-fighter-looping-problem-with-utility/76886/2 "2018-01-24T03:40:01Z")
Happen to me once after updating the firmware. Did you try to uninstall the driver and than plug TW back in to a PC?
Also, when plugging in Twister for the first time, be sure not to use USB sockets on your case front because those are basically an USB HUB’s in 90% of cases. Instead connect it directly in to USB socket on your motherboard and let the software to install.
Also have you tried different PC?