Midi Fighter+VCI100se setup on Traktor 126

DJTT Gear & Custom Mods Midi Fighters
1

Midi Fighter+VCI100se setup on Traktor 126

Hi,
finally I got the Midi Fighter (3/500).
I didn’t understand how to keep together the tsi file of Vci and the tsi of MF.
Only VCI or MF one by one go right with its own tsi. The other interface doesn’t respond to commands, but traktor shows anyway a midi activity
Is somewhere a 3d about it? I didn’t found it.

Another little question: with tsi 1.1 using MF remains steady on the led signed by “x”:
oooo
oooo
ooxo
oooo
Is it a normal status or is it a problem?

My VCI tsi is 2.5 version.
Thanks a lot for help.

2

I found the solution: in traktor, with Vci properly functioning, in ‘controller manager’ → ‘device setup’ I choosed ‘Add..’ → ‘import’ the tsi MF file.
I properly set for every device its own ‘IN port’ and ‘OUT port’.
Midi indicator in traktor is blue so VCI and Mf work fine together.

Now another “always on led” bring me away from complete satisfaction:
that of cue point 8 (anyway it works fine in creating or deleting the cue):
OOOO
OOOO
OOOX
OOOO

Do you think I need to flash the firmware?
Thanks.

3

Ok, perhaps I will become one day a guru to understand mappings.
The led always on shows the focus deck. Sorry.:wink:

4

Hey Wide,

the Four LEDS on the bottom right had corner are to signify which deck is currently active Kinda like this:

OOOO
OOOO
OOAB
OOCD

I assume this is a designed feature, it shows like this when you are not in, slice, record or sample mode. Hope this helps.

Cheers

5

Thanks, at the end I did understand. Now I’m working with deckalized focus mapping. Great!