New Controller Case
Hi all, This year i’ve been doing a GCSE Design & Technology project based around a case for a Kontrol S4 (or smaller controller). For my write-up I need a couple of short statements from potential buyers about it, so if you could say something constructive i’d be really grateful!
It is made of 1.5mm steel with a wooden lining with storage space. The lid is made of acrylic and slides back to allow access to the controller and act as a laptop stand. The lining has a small section at the front to allow for headphone routing, and the entire rear panel is removed to allow for cable-routing. Also, it would be possible to create inserts to fit smaller controllers, in case you don’t have an S4.
!(http://i1218.photobucket.com/albums/dd406/lexion610/DT project/CharliequickGCSEDT031.jpg)
!(http://i1218.photobucket.com/albums/dd406/lexion610/DT project/CharliequickGCSEDT030.jpg)
!(http://i1218.photobucket.com/albums/dd406/lexion610/DT project/CharliequickGCSEDT029.jpg)
Headphone hole
!(http://i1218.photobucket.com/albums/dd406/lexion610/DT project/CharliequickGCSEDT028.jpg)
Cable routing
!(http://i1218.photobucket.com/albums/dd406/lexion610/DT project/CharliequickGCSEDT027.jpg)
Misc. storage space
!(http://i1218.photobucket.com/albums/dd406/lexion610/DT project/CharliequickGCSEDT026.jpg)
!(http://i1218.photobucket.com/albums/dd406/lexion610/DT project/CharliequickGCSEDT025.jpg)
Toggle latches to hold the lid closed
the problem you would have with this design from a buyers POV thou is the fact it will only work on a large surface. There is no way you could take it anywhere other then your house which brings in the facts : Your gear is safest in your house (not needing a case) and you only need a case to carry your gear and protect it when playing in a club/party…normally you have no space to set up a controller so smaller is better