Hi and thnx I already use these commands for loops, I think,
I was just wondering how to setup an encoder on the nocturne 2 make it work with the “beat jump” function that I actually use to put cue points every 8 or 16 or 32 steps… instead of buttons on the org nanoKontrol I use 6 buttons with the beat jump functions those would be button setup like Button - hold - -8 +8 , -16 +16 , -32 +32 this works flawlessly but If I want to make the same function with an encoder it just flashes…
The sensitivity and acceleration settings would be???
Thnx 4 taking your time 2 help me Stewe
this is how it skips i changed it to 3Fh but the same results, it kind of goes fast, and not smooth, it skips fast and at some point it blocks and doesn’t do anything…
Thanks for the vid mate. From the looks of it, looks like your encoders are set to absolute mode (0-127)… Is there some midi editor software available for your controller that you can use to change encoder in to relative mode?
yeah gonna check it might be with the automap app but don’t know what functions it should be
it’s the below settings thnx there’s 3 modes would I then have 2 change the settings back to 7Fh or 3fh?
Lemme know anyway I’ll read the rest tomorrow good night
with a normal sensitivity of 100 and acceleration of 0 in both modes direct or relative,
