Numark N4 Traktor Cue Problem
Okay so I have a Numark N4 and I’m running it with Traktor Pro 2. I have the mapping that Numark gives on the product page of the N4. However, I ran into a problem. When I cue a track it plays out both my speakers which are set to master and my headphones which are set to monitors. I only want to hear the cue through my headphones, not my speakers. So basically I want the cue not to come out of the master, only the monitors. Any help is much appreciated. Thanks.
Set mixing mode to internal under Output routing Tab
Output monitor to 3 & 4
Output master to 1 & 2
That is what I’ve had it set at, yet the problem still persists.
Audio setup of course is set to N4?
What is the soundcard selected?
Also what output of N4 do you have connected to your speakers maybe you have them backwards so you set the output in the Output routing tab instead to
Output monitor to 1 & 2
Output master to 3 & 4
Soundcard is set to the N4 soundcard.
Nope it’s set to Master 0&1 and Monitor is 2&3.
Make sure either the balanced outputs or RCA master output on the back of the N4 are connected to your speakers. Like before just check that the output in the Output routing tab is set to
Output monitor to 1 & 2
Output master to 3 & 4
Quit Traktor turn off N4
Now restart N4 and then Traktor
Still doesn’t work… thanks for the suggestions though I really appreciate it.
Have you checked to see that the knob controlling the cue/master isn’t set over to master?
Yeah, it’s all the way over at cue.
How to solve problem!
The problem is not with the output routing, after several hours I found that this was turned to master in traktor itself. So the cue-signal the mixer received was correct, only that traktor was sending the master.
Help me
I’m sorry i my English is not very clear..
Could you please explain me step by step how did you solve te problem?
I didn’t understand :s
It would help me a lot.
it still doesn’t work