# Omnicontrol Problems

**URL:** <https://forum.djtechtools.com/t/omnicontrol-problems/9888>\
**Category:** Hardware: Controllers, Mods and Gear\
**Created:** [March 24, 2010, 11:22am UTC](https://forum.djtechtools.com/t/omnicontrol-problems/9888 "2010-03-24T11:22:38Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Blubb](https://avatars.discourse-cdn.com/v4/letter/b/51bf81/32.png) [@Blubb](https://forum.djtechtools.com/u/Blubb)\
**Post date:** [March 24, 2010, 11:22am UTC](https://forum.djtechtools.com/t/omnicontrol-problems/9888/1 "2010-03-24T11:22:38Z")

</div>

**Omnicontrol Problems**

Hey fellows,

i already posted on that issue yesterday (under controller mappings) but since i assume, it is not a direct mapping problem and nobody answered I’d like to post again in this subsection. Here’s the problem :

i recently got my hands on a “numark omnicontrol” and went out to modify the supplied Traktor midi mapping according to my needs (Traktor Pro 1.2). Well, everything went fine until i wanted to configure some modify-actions… it didn’t went well, even after consulting myriads of tutorials on that issue.

Ok, whats the deal ? I started out on a blank mapping and wanted to just make one button LED on when pressing it (MOD = 1). I configured the button as Modifier IN using MIDI learn, it sends on Ch01.F4, which is my “Pitch bend down on Deck A”. Afterwards I tried to configure the Modifier OUT and told Traktor to send to Ch01.F4, which seemed logical to me. What I achieved was an LED ON for the “Key”-button of Deck B ! Wtf… now I was interested, how Numark managed this problem in their mapping. I discovered, that they ARE sending on out the signals on a different note, in my case it was Ch01.-C1.

Allright. Is it right, that LEDs receive signals on extra notes, not further related to the buttons above ? I’m no midi-geek, maybe this question sounds silly to most of you, sorry. If so, what am I supposed to do ? I have no clue, which button / LED receives which note so I see no chance how I’ll ever map that thing properly … and still become one of the most respected DJs 😉

ok, I hope, somebody can give me a hint or at least a good workaround. thanks in advance,

Blubb

PS: Btw. i’ve been searching blisters on my fingers, found nothing on this board and anywhere else…

---

<div class="post-metadata">

**Author:** ![Mixer\_Miyagi](https://sea1.discourse-cdn.com/flex001/user_avatar/forum.djtechtools.com/mixer_miyagi/32/10337_2.png) [@Mixer\_Miyagi](https://forum.djtechtools.com/u/Mixer_Miyagi)\
**Post date:** [March 24, 2010, 5:42pm UTC](https://forum.djtechtools.com/t/omnicontrol-problems/9888/2 "2010-03-24T17:42:42Z")

</div>

Are you sure you are using the right midi notes. I have a stealth, same thing. I went through my map, deleted all the LED commands. Made my physical map. Then went through using this picture and easily mapped all the LEDs afterward.
