I’m trying to make a FX mapping on my Twister with all the FX I like. Some “stolen”, some homemade.
The problem is that I can’t get all 3 FX Buttons to turn On att the same time when pressing a Knob on Twister in FX Group Mode. It’s only the third FX Button that turns On. The other 2 FX Buttons only turns On when I press the same Knob again. What am I doing wrong?
All assigned to one and the same Knob Press on Twister
If you change all the Effects Selectors to something else than the ones I stated and turn all the buttons Off and then press the Knob you will se what I mean.
Don’t worry for this bit of delay! I thought you might have found your way but anyways here’s what I’ve imported with your TSI.
First of all, no effect settings were exported so I couldn’t hear what exactly this macro effects should sound like in your setup - or maybe I did? Did you use DJTT effect order?
Knob B1: (M2=1_toggle)
Encoder is set for 3Fh mode
pushing a knob loads Beatslicer+92LFO+Delay (Unit 1)
pushing a knob engages FX1+FX2+FX3 another press properly disengages them
pushing a knob sets the correct parameter for those three FX slots
twisting a knob modulates the parameter as it should
Knob B2: (M2=2_toggle)
Encoder is set for standard CC
pushing a knob loads Beatmasher+PeakFilter+Gater (Unit 1)
pushing a knob engages FX1+FX2+FX3 another press doesn’t properly disengages them
pushing a knob sets the correct parameter for those three FX slots
twisting a knob doesn’t do anything (I assume that you didn’t map those jet?)
Change log:
-Added two more lines for the Modifier 2 [B1:if M2=2 then M2=1 ; B2:if M2=1 then M2=2] -The RGB LED under the knobs now properly displays the active Preset.
-Added the FX Store Preset commands for both B1 and B2. This command will save the FX Snapshot so you don’t need to worry about the effect states and have proper instant gratification control when switching between active Knobs.
-Removed the modifier states form the Effect Selectors and push button parameter mappings. Previously this controls would work only if the M2=0 and we don’t want this to happen if/when the other knob is already engaged because the new preset couldn’t be loaded instantly.
-Reset some of Button ON commands that were unnecessary for this functionality.
Is there a simple way to transfer all the settings from Deck A to Deck B? I don’t want to use Device Target and I really hope I don’t have to redo all the mapping to Deck B.
I imported another copy of the mapping and changed everything to Deck B, but then I had 2 copies working at the same time.
Fortunately there is a way.
You can click on the “edit” tab in the Device Menu and then navigate to the “duplicate” and click on it. This will create another copy of the existing mapping device. Now all you need to do is to target specific device to the correct deck.
