s4 EQ knobs.
Hey guys i’m new to the forums im just wondering about possible putting some of the dj tech tools fluro coloured knobs to brighten up the controller.
I was wondering what steps i would need to undertake this task.
Ibtf!
Edit: Actually I don’t think it is that easy… there are a couple of threads on it and I seem to remember someone had to very carefully widen the hole on the bottom of the knob with a screwdriver to make it fit the post properly.
I think the problem was depth actually, knobs wouldn’t go all the way down.
ah yes, same thing happens with my X1 (what a surprise 
slight_smile:
They did manage it though didn’t they?
Yeah, they heated a screwdriver or something and carefully melted the pot on the inside till it had gone properly in. Jason and Yul are the men to ask.
That was me, and it was for the faders only that I had to do a little McGuyvering with a screw driver.
The knobs go on no problem!
They do sit slightly higher than the stock knobs, but it’s not that much higher. You could always drill them out a little to lower them.
Heres the original thread. S4 with DJTT Knobs and Faders