Ok heres the deal…I use a Vextax Typhoon and a Kontrol x1. When i do a sweep I’ll use Iceverb, Peakfilter, and reverb in fx bank 1. I mapped one knob to control the dry/wet amnt, and then also the amnt of the 3 effects all together (wicked simple mapping).
What I want is when I start to turn that knob, it automatically snaps those 3 FX’s into fx bank 1.
I would bet that this is posted somewhere on here already but after 3 hours of looking around and learning about smart knobs, super knobs, modifiers and advanced modifiers and still not finding out how to do that specifically, I was hoping one of you more experienced guys could answer the question for me in a few simple sentences.
add in:
a modifier that is your knob/ set as a button on ‘hold’ for a value of 1
global> fX panel mode to group and assign accordingly, add the modifier condition =1
add all parameters linked to your chosen group of fx (all is within the drop down menu), add your modifier condition =1
i guess i still don’t fully understand. I just tried for like an hr to figure it out.
Basically i got a blank knob, i want that knob, when i turn it up to turn on and snap to Iceverb, Peakfilter, and reverb in fx bank 3 (changed my idea of where i wanted it) and correspondingly turn up the amount and dry/wet amount of Iceverb, Peakfilter, and reverb. then when i turn it back down, shut those 3 off.
I was wondering what the hell you were talking about, but you’re generally smarter than me about midi mapping so I wasn’t going to say anything until I could sit down and check out what you were saying.
