Traktor internal mixer sync with midi mixer

DJ Software & Apps Controller Mappings
1

Traktor internal mixer sync with midi mixer

Hello,

I’m (sometimes) using a Behringer CMD-MM1 midi mixer to control the Traktor Pro 2 internal mixer.
My problem is that if the commands on the controller & inside traktor mixer aren’t set to identical value,
I’ve to move them all to “synchronise” values.

Is there a solution for this problem ? Maybe a midi command is available to send all the pots & fader values at once to traktor ?

Thanks in advance

2

Unfortunately there isn’t an option in Traktor’s MIDI mapping that accepts information from any controllers. Thing’s that this kind of functionality lives inside of NI controllers and their native mappings.

3

It’s a really annoying problem.
Is it possible to emulate the NI protocol (NHL?)
maybe a soft between Traktor and the controller which convert
midi to NHL ?

4

I don´t believe it is possible to convert midi into NI´s NHL protocol.

in case (for example) your faders on the controller are set to a different value than your virtual faders in traktor, you can use the soft takeover function. then your faders will move the virtual faders when the values match.

5

Yea you can try by looking at the soft take over function in all your mappings.

What you also might try, is mapping a useless modifier to a button, and then give every fader and rotary you want to sync a modifier condition.

For example:
Choose a button which you don’t really use on the controller.
Map a modifier (1 for the example) to a button 2 times, 1 having the modifier condition: modifier 1 = 0, make it a hold button, and make it set the modifier to 1, then the second modifier you have on the same button should be like: modifier 1=1, hold, set to 0.
If you got this correctly you have made a simple hold modifier, which changes to 1 when you hold it.

Now set every fader/ rotary you want to sync up with your controller, to modifier condition m1=0

Now you’ll notice that when you release to modifier button and it changes back to m1=0 all the faders and rotaries jump to the values of your controller.

Note: Turn of all the soft take overs when you do this or it will not work.
Note2: Do not set the faders/rotaries to modifier condition m1=1 or else your faders and rotaries won’t work when your not holding the modifier button.

Hope this is what you were looking for.